Installation
How to Wire the Aquavoss AV-2 and AV-8 (220V Electrical Setup Guide)
The hot tub system of the Aquavoss AV-2 and the Aquavoss AV-8 runs on a 220V-240V single-phase hard-wired electrical connection. As such, the electrical hookup must be completed by a licensed electrician. The electrician will run wiring from your mai
How to Install the Aquavoss AV-2 Chiller
1. Remove the chiller from the cold plunge tank. The chiller was strapped securely inside of the unit. As you were uncrating the unit, you should have seen signage and warning labels indicating where the chiller is and that it must be removed prior t
How to Find & Hire a Hot Tub Mover
The AV-2 is an expensive purchase that demands careful preparation. We ship your order exclusively with our trusted carrier partners. The hot tub is very securely packaged in an enclosed wooden crate – this ensures that it is delivered to you safely.
How to Install Filters on Your Aquavoss AV-2 - Hot Side
Keeping your filters properly installed is key to maintaining clean water and ensuring your system runs efficiently. This quick guide will walk you through how to install your filters correctly. If you prefer to follow along visually, you can watch t
Wiring the AV-2 Cold Side Chiller Through the Hot Side Balboa Control Pack
The AV-2 is shipped from the factory with the cold-side chiller powered independently through a standard GFCI-protected power cord. In some installations, customers may prefer to power the cold-side chiller directly from the hot-side Balboa control p
Starting Your Cold Plunge in Hot Weather
In very hot weather, especially in direct sunlight or during the hottest part of the day, your cold plunge may need a little help during the initial startup. If the starting water temperature is above 80°F, or if the outdoor temperature is very high,